 |
     
I accept a call about consultation and estimate about a flowmeter.Please
feel free to inquire from a phone.
TEL:06(6855)1126
FAX:06(6855)1129
|
|
    
The flow meter will produce by order
based on the condition used.
In the case of an estimate, please direct the measured fluid name, range of flowing
quantity, pressure, temperature,etc.
 It
is necessary for measuring liquid (specific gravity and viscosity).
When the liquid of the water corresponding is measured, it is of no matter, but
we be designed and product with specific gravity and viscosity. A temperature
variation is a big influence is exerted on the display of flowing quantity, so
please keep a fixed temperature as much as possible.
It
is necessary for measuring gas (pressure and temperature).
we will set the condition of the measured gas (pressure and temperature) and produce
the flow meter for the gas.
The flow quantity becomes flow quantity converted into normal condition (atmospheric
pressure 20 degrees Celsius).
In addition, we produce even a standard state (atmospheric pressure 0 degrees
Celsius) by a demand.
 Fig.
A, pressure 0.3MPa joins the needle valve and figure A becomes a state (atmospheric
pressure) without pressure drag after it.Setting pressure is atmospheric pressure
(1atm).
Fig. B, Pressure 0.3MPa joins the flow meter and the needle valve, and even when
be that the atmospheric pressure or some load pressures joins after that, set
pressure becomes 0.3MPa.
Please always do setting pressure in the state that constant pressure hung over
to a flowmeter by pressure when gas to measure passes by in a flowmeter.In addition,
when pressure and the temperature change, it will correct it by the value of fluctuations.
Precision
The principle of accuracy is within based on JIS ｱ2%- ｱ5% of maximum scale value
(F.S). However, accuracy might decrease when it is the following.
- Minute flow quantity
- Liquid of high viscosity
- Gas with extremely small density
Withstand pressure/ leakage inspection
It does by the pressure 1.5 times the maximum use pressure.
Flow correction formula
Liquid correction formula
| When the density is different in the different kind liquid |
| |
 |
Different kind gas, Pressure and temperature correction formula
| When the unit of pressure is kPa |
| |
 |
| When the unit of pressure is kgf/cm2(G) |
| |
 |
Steam correction formula
| |
 |
| *In general, the steam shows Mass(weight) by the unit |
Explanation of sign
| |
Q |
: |
True flow quantity |
| |
q |
: |
Flow quantity on a dial |
| |
ρf |
: |
Density of a float |
| |
ρ0 |
: |
Density of a fluid on a dial |
| |
ρ1 |
: |
Density of a different fluid |
| |
P0 |
: |
Pressure (kPa/kgf/cm2G) on a dial |
| |
P1 |
: |
Different pressure (kPa/kgf/cm2G) |
| |
T0 |
: |
Temperature on a dial |
| |
T1 |
: |
Different temperature |
| |
W1 |
: |
True flow quantity (mass) |
| |
W0 |
: |
Flow quantity (mass) on a dial |
| |
γ0 |
: |
Density of steam on a dial |
| |
γ1 |
: |
Density of different steam |
|
 |
|
|
